Pretreatment
Ensure surfaces to be bonded are clean and free of dust, grease or oil. Pooled water should be removed. Substrates must be stable. Remove any contaminants likely to impair adhesion. Before application, mask off the adjacent area with foil or tape, if necessary. Check paint or coatings are firmly attached, if not remove it.
Application
2)Cut off tip of the cartridge above the screw thread. 2)Screw on plastic nozzle and diagonally cut off the tip of the nozzle. 3)Place cartridge into gun. Apply adhesive onto one of the surfaces: In spots (1) in order to smooth uneven surfaces, in wave-like form
(2) for higher initial tack with wide surfaces or in straight beads for smaller surfaces (3). In case of outdoor use, apply vertical beads.Release gun after appliance to stop adhesive from flowing (not valid for Foldable Gun (DW111/120).Ensure Ventilation. (1 mm Minimum gap)
Important in case of 2 non-absorbent surfaces: Adhesive must not form continuous areas as contact with air is necessary for adhesive setting. Then put the two surfaces together, correct if necessary, and press firmly. Make sure the adhesive tracks do not merge. Heavy items and items under tension have to be supported and fixed for at least 24 hrs.
Cleaning tools
Fresh adhesive may be cleaned with a cloth soaked in a solvent (alcohol or white spirit).
Once fully cured, UniBond No More Nails All Materials Interior & Exterior can only really be removed by mechanical means (i.e. a chisel or similar tool)