No More Nails All Materials Heavy Objects

Features and Benefits

When ultra-high grab is needed, use UniBond No More Nails All Materials Heavy Objects.

Formulated using Henkel patented technology, for interior and exterior use, it can even stick to damp and wet surfaces, providing a flexible, shock resistant bond that won’t let you down – even in extreme weather conditions.

The solvent free, neutral curing system makes UniBond No More Nails All Materials Heavy Objects suitable for bonding sensitive surfaces such as mirrors and natural stone, as well as most common building materials. Temperature and UV resistant when cured, the adhesive fills gaps and will not shrink.

Characteristics

  • Ultra high grab: Holds up to 350kg per m²
  • Highly durable: Water, UV, vibration and weather resistance. 
  • Heavy Objects Multi-materials: Suitable for fixing most common absorbent and non-absorbent materials such as stone, metal, glass and wood in any combination.
Read More

Available sizes:

440 g

Documents and Downloads

  • 440 g - IDH 2675587
UniBond No More Nails All Materials Heavy Objects Cartridge 440g 2675587 en-GB

Safety Data Sheet
No documents found

Additional Documents

How to use 

Pretreatment

The surfaces to be bonded must be clean, free from oils, grease, dust and loose particles. Pooled water should be removed. Check paint or coatings are firmly attached, if not remove it. In cases of unknown materials or critical applications adhesion pre-tests are recommended.

Application

1) Cut off tip of the cartridge above the screw thread. 2) Screw on plastic nozzle and cut off the tip of the nozzle. 3) Place cartridge into gun. Because of the very high tack formula, the product has a high resistance to extrude. Therefore cut nozzle sufficient (min. 8mm diameter) or in a V-shape. Apply adhesive onto the surface of one of the elements to be bonded: In spots (1) in order to smooth uneven surfaces, in wave-like form (2) for higher initial tack with large surfaces or in straight beads for smaller surfaces (3). In case of outdoor use, apply vertical strands.Release gun after appliance to stop adhesive flow. (not valid for Foldable Gun (DW111/120). Firmly fix items to be bonded into position with a twisting action. If necessary (e.g. heavy items and items under tension), support the items until cured. Items can be adjusted after application. Minimum thickness of the adhesive layer should be 1 mm to ensure ventilation.

Important in case of 2 non-absorbent surfaces: Adhesive must not form continuous areas as contact with air/moisture is necessary for adhesive setting. Make sure the adhesive beads do not merge.

For filling applications

Maximum joint width: 20mm. Firmly extrude UniBond No More Nails All Materials Heavy Objects into the gap and make sure that it is a full contact with the sides of the gap. Fill the gap and avoid air entrapment. Product should be tooled firmly against the gap sides to ensure good adhesion. 

Cleaning

Clean tools and application equipment immediately using white spirit or ethanol. Cured product can only be removed mechanically (e.g. with a knife or a scraper).