Key Facts

Product Introduction:

The Triple Protection system repels and kills mould. The revolutionary slow release anti-mould fungicide lasts more than 50% longer than standard fungicides.


Product Features:

Application :

  • Suitable for dry and intermittently wet areas
  • For fixing ceramic wall tiles up to 300mm x 300mm on absorbent surfaces
  • For interior use

Tips and tricks:

Preparation is key

Plan your tile layout before starting. Work out your base lines and starting points to avoid awkward cuts at edges and around windows.

How many tiles do I need?

When calculating how many tiles you need, work out how many will cover the area to be tiled – and then add 10% for breakages. You can always return the extra tiles if you don’t use them.

Cutting Tiles

For awkward cuts, it’s recommended that you make a template out of card and trace around it. Always remember to wear goggles and gloves when cutting tiles.

Spacers

Use spacers to ensure regular spacing of tiles. Occasionally check with a spirit level to ensure the tiles remain level.

Clean up act

Ensure you remove the excess residue left over from tile adhesive immediately, whilst it’s wet.

Grouting

When grouting wipe diagonally across the tiles to avoid dragging the new grout lines. To maintain a mould-free grout, clean regularly with an anti-bacterial cleaner.

Content: 

  • 12.8kg
  • 6.4kg
  • 1.28kg

Storage:

Store in cool dry conditions. Protect from frost and direct sunlight.

Project check list

  • Tile Adhesive
  • Measure & Spirit Level – To find centre and base lines
  • Notched Trowel – For spreading the tile adhesive to the correct depth
  • Bucket Trowel – For getting the tile adhesive out of the bucket
  • Tile Spacers – To ensure  tiles are spaced  evenly
  • Sponge & Bucket of clean water – To remove excess adhesive from tile face immediately
  • Tile Cutter
  • Grout
  • Grout Float – For applying the grout to the grout lines

Step by Step

Fixing Tiles:

1. Ensure the surface to be tiled is even, sound and dry. Prime if necessary.

2. As a general rule tiling should be set out from the centre of the wall.

3. Using a spirit level draw a horizontal line one tile height above lowest point to be tiled.

4. Draw a vertical centre line avoiding awkward cuts on the edges.

5. Begin tiling at the intersection of these two points.

6. Spread the adhesive evenly using a notched trowel. Always apply the adhesive to the wall and not the tile

7. Work in manageable areas of about 1m₂ to ensure adhesive doesn’t dry out – Fix tiles within 30 minutes of spreading adhesive

8. Bed tiles firmly into the adhesive using a twisting action to ensure good contact

9. Use tile spacers to position the tiles evenly and accurately

10. Remove any surplus adhesive immediately with damp cloth

Grouting:

1. Do not start grouting until the adhesive is fully dry.

2. Press the grout into the joints with a grout float.

3. Ensure that the joints are completely filled.

4. Smooth off the grout lines with a grouting tool.

5. Immediately remove the excess grout with a damp cloth.

6. Allow to dry for 24 hours then polish the tiles with a clean cloth – ensure that the grout is fully dry before allowing water contact.

*For guidance only, please refer to pack for more concise instructions.