Key Facts

Product Introduction:

To tile over wooden floors use UniBond ready mixed floor tile adhesive and grout.


Product Features:

Application :

  • For fixing ceramic floor tiles on to interior wooden floors
  • Tile over pre-fitted underfloor heating
  • Suitable for most absorbent wooden floors

Tips and tricks:

Preparation

UniBond Floor tile adhesive & grout for wooden floors is a thin bed adhesive and must not be laid to a bed depth of greater than 3mm, therefore repair or replace uneven floorboards.

Setting Out

Lay dry tiles on the floor and arrange so that difficult cuts and awkward corners are avoided.

How many tiles do I need?

When calculating how many tiles you need, work out how many will cover the area to be tiled – and then add 10% for breakages. You can always return the extra tiles if you don’t use them.

Cutting Tiles

For awkward cuts, it’s recommended that you make a template out of card and trace around it. Always remember to wear goggles and gloves when cutting tiles.

Spacers

Use spacers to ensure regular spacing of tiles. Occasionally check with a spirit level to ensure the tiles remain level.

Checking

Occasionally lift a tile that has been recently laid to ensure full adhesive contact is being achieved.

Content: 

  • 14.3kg

Storage:

Store in cool dry conditions. Protect from frost and direct sunlight.

Project check list

  • Tile Adhesive
  • Measure & Spirit Level – To find centre
  • Notched Trowel – For spreading the tile adhesive to the correct depth
  • Bucket Trowel – For getting the tile adhesive out of the bucket
  • Tile Spacers – To ensure  tiles are spaced  evenly
  • Sponge & Bucket of clean water – To remove excess adhesive from tile face immediately
  • Tile Cutter
  • Grout
  • Grout Float – For applying the grout to the grout lines

Step by Step

Preparation:

1. Movement should be limited to the natural movement of the wood. Screw the floor at 300mm centres through the joists. Plywood floors should be at least 15mm thick.

2. Allow new wooden floors to settle before tiling

Fixing Tiles:

1. Apply a continuous bed of adhesive up to 3mm thick over 1m2 using a notched trowel.

2. Bed the tiles firmly into the adhesive using a twisting action to ensure full contact.

3. Tile spacers should be used to ensure regular spacing.

4. Remove surplus adhesive immediately with a damp cloth.

5. Adhesive sets in 48 hours.

Grouting:

1. Do not start grouting until the adhesive is fully dry.

2. Press the grout into the joints with a grout float.

3. Ensure that the joints are completely filled.

4. Smooth off the grout lines with a grouting tool.

5. Immediately remove the excess grout with a damp cloth.

6. Allow to dry for 24 hours then polish the tiles with a clean cloth – ensure that the grout is fully dry before allowing water contact.

*For guidance only, please refer to pack for more concise instructions.